Brandt BT600LE Manuel D'instruction page 14

1 - 1 -
3 - PROGRAMMING
D
ELAYED START OF A PROGRAMME
You can delay your cycle using
7
button . By pressing the button several times,
you can delay the start of the cycle by 3, 6, 9 or 12
hours.
1
Press button "Start/Pause" to confirm.
The cycle 8 lights flash in sequence to indicate
that your programming has been registered and
the lights around the "Start/Pause" button switch
on. . Depending on your selected options, one, two
or three LEDs will come on at the same time
(Diagram 3.2.2) . The LEDs will go out one by one
every 3 hours until the cycle actually starts.
A
DDING OR REMOVING AN ITEM DURING THE
CYCLE (impossible during spin)
Press and hold the "Start/Pause" button
rupt the programme.
8
The cycle light and the lights around the
"Start/Pause" button flash.
Insert or remove the linen.
The time taken to unlock the door depends
on the temperature inside the machine and
can last up to several minutes for safety reasons.
9
Press "On/Off" to restart the programme.
8
The cycle light and the lights around the
"Start/Pause" button are fixed.
Nota : If you have selected a delayed start, you can
open the drum at any time before the wash pro-
gramme starts.
C
ANCELLING A PROGRAMME
Press and hold the "On/Off" button
All the lights go out.
This operation may be made at any time, during the
cycle or when programming or even when paused.
Nota : In all cases, cancelling a programme means
that you have to re-programme everything from the
start again (see paragraph 3.2) .
Information :
In the event of a power cut, the cycle will automati-
cally restart from the point where it stopped, as
soon as the power returns.
EN
(continued)
1
to inter-
9
.
14
E
ND OF THE WASHING CYCLE
The "End" light comes on and a beep sounds to
inform you of the end of the programme. This light
automatically goes out after a maximum of 5
minutes in order to save energy in the standby
mode.
Open the lid and remove the linen.
Some models automatically position the drum with
the opening at the top to make it easier to take the
linen out. This operation only lasts 3 minutes at
most.
Press and hold the "On/Off"
the washing machine.
C
HILD SAFETY
Activate "Child safety" to lock your programme by
pressing the first and second options buttons at the
same time. Once this safety device is active,
5
light , corresponding to the (
on.
Simultaneously press the same buttons again to
switch off the "Child safety" function.
P A
39 minutes
ROGRAMME OPTI
Programme at 40° lasting 39 minutes with a maxi-
mum of 3kg of cotton or mixed laundry that is mode-
rately dirty that produces a perfect result.
P
25 minutes
ROGRAMME FLASH
Program at 30° C for 25 minute washing cycle, maxi-
mum of 2.5 kg of lightly soiled cotton or mixed laun-
dry.
Important : For this programme, the doses of
detergent should be reduced by half.
P
ROGRAMME COTTON P
To remove earth, sand, blood... This sequence
includes a wash in clean water.
It is also necessary to put a detergent (wash-
ing powder only) in the prewash product com-
(Diagram 2.2) .
partment
S
HIRT PROGRAMME
This programme is specially designed to wash six
moderately soiled shirts that have been worn for one
day in less than 40 minutes. The spin speed is adjus-
ted to limit wrinkling.
D
ELICATES PROGRAMME
This programme is specially designed for an ultra
gentle wash (swing wash) that does not felt or pill
even your most delicate wools. It is advisable to turn
your woollen clothes inside out before washing
them.
R
/S
INSE PIN PROGRAMME
When this programme is selected, the "Sensitive
skin" option is activated automatically. Deactivate
this option for spin drying only.
9
button to switch off
) symbol ,comes
rewash