Hilti TE 2 Mode D'emploi page 23

To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with the product can be
found at your local Hilti Store or online at: www.hilti.group.
Replacing the dust shield
▶
Replace the dust shield.
Transport and storage
• Do not transport electric tools with accessory tools fitted.
• Always unplug the supply cord before storing an electric tool or appliance.
• Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
• Check electric tools or appliances for damage after long periods of transport or storage.
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem
by yourself, please contact Hilti Service.
Troubleshooting
Trouble or fault
The power tool doesn't
start.
No hammering action.
The rotary hammer doesn't
achieve full power.
The drill bit cannot be re-
leased.
The drill bit makes no
progress.
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled.
The materials must be correctly separated before they can be recycled. In many countries, your old
*2059547*
9
Possible cause
Interruption in the electric sup-
ply.
The power tool is too cold.
The function selector switch is
set to "Rotary drilling only"
The control switch is not fully
pressed.
TE 2-S
Function selector switch set to
"Light hammering action"
The gauge (cross section) of the
extension cord conductors is
inadequate.
The chuck is not pulled back
fully.
The power tool has been set to
reverse rotation.
2059547
Action to be taken
▶
Plug in another electric tool or
appliance and check whether
it works.
▶
Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶
Set the function selector
. switch to the "Hammer
drilling" position
▶
Press the control switch as far
as it will go.
▶
Set the function selector
switch to the "Hammer
drilling" position
.
▶
Use an extension cord with
an adequate conductor cross
section.
▶
Pull the tool lock back as far
as it will go and remove the
tool.
▶
Set the power tool to forward
rotation.
.
.
17