Hilti TE 2 Mode D'emploi page 20

▶
Observe the nationally applicable industrial safety regulations.
Electrical safety
▶
Before beginning work, check the working area (e.g. using a metal detector) to ensure that
no concealed electric cables or gas and water pipes are present. External metal parts of the
tool may become live, for example, when an electric power line is damaged accidentally. This
presents a serious risk of electric shock.
▶
Check the power tool's supply cord at regular intervals and have it replaced by a qualified
specialist if found to be damaged. If the power tool's supply cord is damaged it must be
replaced with a specially-prepared and approved supply cord available from Hilti Customer
Service. Check extension cords at regular intervals and replace them if found to be damaged.
Do not touch the supply cord or extension cord if it is damaged while working. Disconnect
the supply cord plug from the power outlet. Damaged supply cords or extension cords present
a risk of electric shock.
Description
Overview of the product
Three-jaw chuck (TE 2-M)
@
Dust shield
;
Chuck
=
Chuck locking ring (TE 2-M)
%
Depth gauge
&
Function selector switch
(
Intended use
The product described is an electrically powered rotary hammer. It is designed for drilling in concrete,
masonry, drywall / gypsum board, plastic, wood, metal and for driving and removing screws.
▶
The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type plate.
Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or
online at: www.hilti.group | USA: www.hilti.com
Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific
type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the tool. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Product generation
Weight in accordance
with EPTA procedure 01
Drilling diameter range
in concrete/masonry
(hammer drill bit)
14
1
TE 2
02
2.7 kg
4 mm ... 22 mm
Forward / reverse switch
)
Grip
+
Control switch
§
Lockbutton
/
Rating plate
:
Side handle
∙
TE 2-S
02
2.7 kg
4 mm ... 22 mm
2059547
TE 2­M
02
2.9 kg
4 mm ... 22 mm
*2059547*