Hilti TE 2 Mode D'emploi page 22

TE 2-M
Fitting / removing the chuck
Fitting/removing the drill bit or other accessory: SDS chuck
Use of unsuitable grease may cause damage to the product. Use only the recom-
mended grease supplied by Hilti.
TE 2-M
Fitting/removing the drill bit or other accessory: Quick-release chuck
Adjusting the depth gauge
Always pay attention to the maximum length of the depth gauge.
Drilling with hammering action (hammer drilling)
TE 2-S
Light hammering action
TE 2
TE 2-S
Drilling
TE 2-M
Drilling in first gear
Forward / reverse
ATTENTION
Risk of damage Actuation while the tool is running may result in damage to the gearing.
▶
Do not operate the forward / reverse switch while the motor is running.
Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a
power outlet can lead to severe injury and burns.
▶
Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone
as they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries
including burns.
▶
Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that
they all function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function
correctly.
16
or drilling in second gear
2059547
*2059547*
3
4
5
6
7
7
7
7
8