Publicité
Owner's manual
DAILY USE
SWITCHING THE HOB ON/OFF
To turn the hob on, press the power button for around 1 second.
To turn the hob o , press the same button again, and all cooking zones will
be deactivated.
POSITIONING
Locate the desired cooking zone by referring to the position symbols.
Do not cover the control panel symbols with the cooking pot.
Please note: In the cooking zones close to the control panel, it is advisable to
keep pots and pans inside the markings (taking both the bottom of the pan
and the upper edge into consideration, as this tends to be larger).
This prevents excessive overheating of the keypad. When grilling or frying,
please use the rear cooking zones wherever possible.
ACTIVATING/DEACTIVATING COOKING ZONES AND ADJUSTING POWER
LEVELS
To activate the cooking zones:
Press the "+" or "−" button of the required cooking zone to activate it and adjust
the power. The level will be shown in line with the area and the indicator light
identifying the active cooking zone. The "P" button can be used to select the
fast heating function (Booster).
FUNCTIONS
EXTENDIBLE ZONE DOUBLE ZONE
Depending on the container's diameter, the zone adapts itself
automatically, turning on partially (inner zone) or completely (outer zone).
For more information, refer to the minimum diameter table.
IMPORTANT: Place the pot making sure that its center corresponds to the
center of the cooking zone in use (as shown below).
CONNEXION ZONE
It allows to combine two cooking zones and use them as a single large area.
Ideal for sh kettles, pots or grilles that cover the entire cooking surface.
The function is de-activated if the bridge area is not entirely covered.
Either of the keypads on the left can be used.
To activate/deactivate the function, press the "CONNEXION ZONE" button.
N.B. Special functions cannot be selected when using this feature.
To deactivate the cooking zones:
Press the "OFF" button to the left of the power adjustment.
OK
3 sec
To lock the settings and prevent it from accidentally switching on, press
and hold the OK/Key lock button for 3 seconds. A beep and a warning
light above the symbol indicate that this function has been activated. The
control panel is locked except for the switching o function (
the controls, repeat the activation procedure.
There are two timers - one controls the left-hand cooking zones, while
the other controls the right-hand cooking zones.
To activate the timer:
Press the "+" or "−" button to set the desired time on the cooking zone in use.
An indicator light will be activated in line with the speci c symbol . Once
the set time has elapsed, a beep will sound, and the cooking zone will switch
o automatically.
The time can be changed at any point, and several timers can be activated
simultaneously.
In case 2 timers on the same side of the hob are activated simultaneously,
"Zone selection indicator" ashes and the relative cooking time selected is
displayed on the central display".
P
To deactivate the timer:
Press the "+" and "−" buttons together until the timer is deactivated.
This LED (when ON) indicates that the timer has been set for the cooking zone.
IMPORTANT: Place the pots in the center of the cooking zone so that they
cover at least one of the reference points (as shown below).
The "6
th
Place the pot in position and select the cooking zone.
Press the "6
The indicator for the rst special feature available for the cooking zone will
light up.
Select the desired special function by pressing the "6
more times.
The function is activated once the
CONTROL PANEL LOCK
TIMER
TIMER INDICATOR
6
SENSE
TH
Sense" button activates the special functions.
Sense" button. The display of the selected area will show "A".
th
OK
3 sec
EN
). To unlock
Sense" button one or
th
button has been pressed to con rm.
Publicité
