Publicité
Where breakage or damage to leds occurs
the product must not be used/energised but
disposed of safely.
This product's external flexible tube is non-
replaceable. Hence if it becomes damaged
you must dispose of the entire product.
This product does not contain any parts which
can be serviced by the user. The LEDs cannot
be replaced.
Only use the product with the supplied mains
adapter for the type (Model No.
23S0900G300W8D); all warranty claims will
otherwise expire.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the mains cable from sharp edges,
mechanical loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always unplug the mains adapter from the
socket before installation, dismantling or cleaning.
Never touch the mains adapter or the product
itself with wet hands.
The product must not be electrically connected
to another set of lights.
If the product is not in use for any length of
time (e.g. holidays), disconnect it from the
power supply.
If you have any questions about the product
or are unsure about any of its aspects, please
seek the advice of an electrical equipment
specialist.
The product is only suited for use with the
included mains adapter (Model No.
23S0900G300W8D).
Please note that the mains adapter continues
to draw a small amount of power even if the
product is turned off as long as the mains
adapter is plugged into a power outlet. To
switch the product off completely, unplug the
mains adapter from the socket.
The LEDs are not replaceable.
If the LEDs fail at the end of their lives, the
entire product must be replaced.
This product must not be
used without all gaskets
installed.
8
GB/IE/NI
being properly
6
Do not operate the light chain
in the packaging or when it is rolled
up.
The LED driver can only be replaced by a
professional.
The light chain isn't allowed to connect to
220‒240 V ~ without LED driver.
Use
Note: Remove all packaging materials from the
product.
Note: The LEDs are connected in series. If one
LED is defective, up to ten LEDs may not light up.
Insert the plug on end of the product into the
socket of the mains adapter
the mains adapter
supply line must be observed. Please screw
down the connecting nut
Insert the mains adapter
Press the timer and mode button
the light chain
.
1
Press the Timer and mode button
switch to the next lighting mode. When you reach
lighting mode 8, the next press of the Timer and
mode button
switches the product off.
2
The light mode is listed as below:
1. Combination
2. In wave
3. Sequential
4. Slo-Glo
5. Chasing/flash
6. Slow fade
7. Twinkle/flash
8. Steady on
9: Off
Timer function
To switch on the timer function, press and hold
the Timer and mode button
uct is connected to the socket of power supply.
The indicate light
5
timer function is activated.
1
. The recess on
3
and on the plug of the
3
clockwise.
4
into the mains socket.
3
to turn on
2
again to
2
after the prod-
2
will light up when the
Publicité
