Publicité
observe all safety instructions for the power drill in the manual for the
power drill. Death or injury due to electric shock may otherwise result.
CAUTION! RISK OF INJURY! Refer to the operating instructions
for your electric drill.
CAUTION! Ensure that you do not damage any cables in the wall.
Please see figure A (with screws
(with double adhesive tape
Note: The substrate should be dry, smooth and free of dust
and grease.
Note: Allow the wall bracket
for at least 24 hours. Otherwise the adhesive action could be
detrimentally affected.
Note: If the double adhesive tape
long time, sticky residue may remain on the surface when removed.
If necessary, use an adhesive remover. Test a small area prior to
cleaning the respective area. Follow the manufacturer instructions.
Attach the product to the wall bracket
wall bracket
Start of operation
Using the product
Note: Before first use remove the insulation strip.
The product will automatically switch on when motion is detected
in a dark environment.
The product will automatically switch off when motion is no longer
detected for a period of time.
Replacing batteries
Loosen the screw on the battery compartment cover (See Fig. C).
Open the battery compartment
Remove the old batteries and insert new batteries (see Fig. C).
Check the polarity of the batteries. This is shown in the battery
compartment
6
as shown in figure D.
4
.
7
and dowels
5
) for mounting the product.
to build up its adhesive bond
4
has been in place for a
6
or detach it from the
4
at the back of the product.
7
) or B
3
GB/IE/NI
11
Publicité
