Publicité
● When it is in the parameter settings page, the mode, fan
speed, and switch buttons are invalid.
● Parameter C14 allows you to return to the home screen after
pressing "
".
Parameter
Parameter
Code
Name
C00
Main and
secondary wired
controller setting
C01
Cooling only/cooling
and heating setting
of wired controller
C02
Auto restart function
setting for the wired
controller
C03
Time to remind
users to clean the
filter on the wired
controller
C04
Settings for infrared
receiver of wired
controller
C05
Whether ambient
temperature is
displayed
Parameter
Range
0 indicates the main wired
0
controller and 1 indicates a
secondary wired controller
00: Cooling and
00
Heating
01: Cooling Only
00: No
00
01: Yes
00/01/02/03/04
01
00: Disable
01
01: Enable
00: No
00
01: Yes
34
Default
Remarks
Value
If two wired controllers control one IDU,
addresses for two wired controllers must be
different. You are not allowed to set IDU
parameters via the secondary wired controller
(address 1), but can set the wired controller.
No Heat mode for wired controller set with
Cooling Only
If the value is set to 00, the wired controller
screen displays cooling, medium fan speed,
and set temperature 24°C after each
power-on. If the value is set to 01, the wired
controller screen displays the mode,
temperature, and fan speed that were
previously set before a power failure upon
each power-on.
00 No filter cleaning reminder
01 1200 hours
02 2500 hours
03 5000 hours
04 10000 hours
When "Disable the infrared receiver of the
wired controller" is on, the wired controller
cannot receive remote control signal.
Common IDU, JR8 AHU-kit, and JR8 FAPU
T1_modify is displayed.
JR6 FAPU and JR6 AHU-kit :Subject to the
unit type
V.1
Publicité
