Publicité
In the address query and setting state, the wired
controller does not respond to or forward any remote
control signal.
5.5.4 Parameter settings of the wired controller
● Parameters can be set in the power-on or power-off state.
● Hold "
" and "
setting interface.
● After entering the parameter setting interface, the ODU
displays u00, the IDU displays n00-n75, and the wired
controller displays CC. Press "
parameter code. Set parameters according to the Table of
Parameter Settings. Press "Swing" to enter the parameter
setting interface. Then press "
parameter value and press "
● Press the "
exiting the parameter setting or exiting the parameter setting
after 60s without any operation.
● When it is in the parameter settings page, the wired controller
does not respond to any remote control signal.
INFORMATION
i
" for 3 seconds to enter the parameter
" button to return to the previous page until
33
" and "
" to switch the
" and "
" to save changes.
" to change
V.1
Publicité
