Antar AT52302 Manuel D'instructions page 11

ENG

Se ngs

1. Seat height (back)

The height of the seat can be adjusted (6 levels of adjustment every 2.5 cm). Remove the rear wheel, use a spanner to loosen the nut on the inside.

Remove the rear wheel holder and insert it to the desired height. Tighten the screw.

Fig. 15

2. Height of the front wheels

The height can be adjusted (5 degrees of adjustment every 1 cm). Loosen the screw with an Allen key and a ﬂ at wrench, and then pull it out of the

holder. Adjust to the desired height and ghten the screw. Make sure both wheels are at the same height.

Fig. 17

3. Seat inclina on angle

By adjus ng the height of the front and rear wheels, you can adjust the angle of the seat by changing the posi on of the wheels downwards and the

inclina on of the seat is increased.

4. The steering angle of the wheels

To prevent the front wheels from shaking a er changing the angle of the seat, adjust the steering angle of the wheels. For this, the front wheel

holder must be posi oned exactly at a 90 ° angle. Loosen the bracket bolts with two ﬂ at wrenches, posi on the bracket perpendicular to the ﬂ oor,

and rea ach the bolts.

Fig. 19

5. Seat depth

The depth of the seat can be adjusted (6 steps every 2.5 cm). A er changing the seat depth, the seat upholstery should be properly adjusted with

Velcro.

Fig. 21

AT52302_ins_multi_001.indd 11

Fig. 16

Fig. 18

Fig. 20

Fig. 22

- 11 -

Fig. 23

Fig. 24

2023-12-27 11:25:23