Bathing - Invacare Aquatec KOGIA Manuel D'utilisation

Élévateur de bain
Masquer les pouces Voir aussi pour Aquatec KOGIA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.3 Bathing

WARNING!
Risk of slipping!
The bath lift can slip if the suction cups do not have a
proper hold.
– Before using the bath lift ensure that it is securely
positioned and cannot tip over.
– Ensure that the bath lift is set up in the bathtub like
described in section 3.3 Setting up the bath lift, page
9 .
WARNING!
– If your condition means that you cannot take a bath
on your own, only use the device with supervision.
– If operating the device without supervision, make sure
to have an alarm system or telephone within reach in
case of unforeseen events (e.g. malfunctions).
CAUTION!
Bath oils or salts can impair the performance of the
lifting scissors.
– If using such bath additives, do not exceed the
recommended dose.
IMPORTANT!
– Run the unloaded lift once to the top and then back to
the bottom (function test).
– Before using, check the temperature of the bath water.
1584939-A
1.
Press and hold the Up button C on the hand control until the
seat is level with the edge of the bathtub.
2.
Make sure that the side flaps are level with the seat plate and
rest flat on the edge of the bathtub (initial position).
3.
Fill the bathtub with water.
4.
Sit on the side flap nearest to you as you would on a chair.
5.
Slide backwards until you are sitting in the middle of the seat.
6.
Turn yourself into the bathing position, by lifting one leg and
then the other over the edge of the bathtub.
7.
Once you are sitting correctly, press the Down button E and
hold it down to lower the seat into the bathtub.
Once the seat has reached the lowest position, it is possible
to recline the backrest by continuing to hold the Down
button E. This produces a more comfortable bathing
position and allows you to immerse yourself deeper in the
bath water.
8.
Keep the Down button pressed until the backrest has reached
the desired position.
To get out of the bathtub, follow these steps in reverse
order.
To raise the backrest or the bath lift, press the Up button C and
9.
keep it pressed until it has reached the desired or initial position.
The hand control can be hung on the hooks at the backrest
when not in use.
IMPORTANT!
– Remove the battery when not used constantly.
Usage
15

Publicité

Table des Matières
loading

Table des Matières