ADEUNIS sigfox RC1 ANALOG PWR Guide De L'utilisateur page 78

sigfox RC1 ANALOG PWR - Guide utilisateur / User guide version V2.0.2
5.7. Starting up the product using a magnet
Once the product has been configured and its assembly has been finalized, the product is ready to be started up.
The start-up is carried out using a magnet which you place on the upper part of the product (cf. the diagram
below). The magnet must be held in position for at least 6 seconds so as to confirm the start-up of the product.
When the magnet is well detected, the green LED lights up for 1 second.
Once the sigfox RC1 ANALOG PWR unit validates its start-up, it immediately transmits status frames followed by a
data frame (according the defined periodicity).
FR
EN
www.ime.de
Position of the magnet
for starting up the prod-
uct
Page 78 of 86