Publicité
Les langues disponibles
Les langues disponibles
sigfox RC1 ANALOG PWR - Guide utilisateur / User guide version V2.0.2
5.
PREPARATION AND START-UP
5.1. Disassembling the casing
The product is delivered disassembled so that you can access the lower part of the electronics. This part enables
the sensor or sensors to be connected to the screw terminals as well as access to the configuration switches.
Once assembly of the sensors has been finalized and the configuration has been carried out, the casing can be
closed.
NB: Once the casing is closed, it will no longer be possible to open it without running the risk of voiding the IP67
protection index guarantee.
5.2. Fitting the packing gland seal
Before connecting your sensor's cable strands to the product's screw terminals, you must insert the packing
gland's nut and the seal appropriate for your configuration.
Three types of seals are supplied with product: For a cable with a diameter of 5 mm, for a cable with a diameter
of 3 mm, and for two cables with diameters of 2.2 mm.
Assembly procedure:
Seal for 1 x 5 mm
diam. cable
5.3. Mounting the sensor on the screw terminals
Once the nut and the packing gland seal are fitted, the sensor cables' strands can be connected to the product
unit's screw terminals.
Note: A maximum of 2 sensors may be used in parallel. The user can choose freely between analog and digital
options
1 - Your sensor
2 -Pass the
and its cable
cable through the
packing gland nut
Analog sensors require an electric power supply. The power supply of the sensor may be the same as that of the
sigfox RC1 ANALOG PWR, provided that the supply voltage is compatible with both.
Seal for 1 x 3 mm
diam. cable
90
3 - Pass the cable
4 - Pass the cable
through the pack-
through the SEN-
ing gland seal
SORS casing base
105
www.ime.de
Seal for 2 x 2.2 mm
diam. cables
27
5 - Fit the O-ring
onto the seal of
the casing base
FR
EN
6 - Connect the
sensor cable
strands to the
screw terminals
Page
75
of 86
Publicité
