Publicité
Levelling the Cooker
Your cooker is supplied with 4 feet for levelling the appliance. If necessary, these feet
can be screwed into the housings in the corners of the cooker base.
Fitting the Anti-tilt Chains and Hooks
To prevent the cooker from tipping forwards in the event of children standing on the
oven door or users putting extreme weight on the door when in open position, two
supplied chains MUST BE fixed to the back of the cooker which should at all times be
secured to the threaded hooks which are securely fixed to the wall.
Wall
Anti-tilt chains on
the left and right
sides
After you have located where the cooker is to be positioned, mark on the wall the
1.
place where the two threaded hooks have to be fitted.
Drill two 8mm diameter holes in the wall and insert the supplied plastic plugs into
2.
the wall.
IMPORTANT! Before drilling the holes, check that you will not damage any pipes or
electrical wires.
Secure the threaded hooks into the plastic plugs.
3.
Move the cooker to the wall and secure the chains to the back of the cooker.
4.
Fitting the Anti-tilt bracket on the Ground
1. Drill a hole into the cabinet bottom.
The distance between the hole and wall or cabinet side must be no less than
50mm.
Threaded hook
EN-8
Plastic plug
Publicité
