Télécharger Imprimer la page

Power Fist 8533606 Manuel D'utilisation page 4

Publicité

V 3.05
8. This device is only for use on 120 V (single phase) and is equipped with a 3-prong grounded power supply
cord and plug.
9. DO NOT use this device with a 2-prong wall receptacle.
a. Choose an available 3-prong power outlet.
b. Replace 2 prong outlet with a grounded 3-prong receptacle, installed in accordance with the CE Code
and local codes and ordinances.
WARNING! All wiring should be performed by a qualified electrician.
Power Cord
1. Insert the power cord plug directly to the power supply whenever possible. Use extension cords or surge
protectors only when the device's power cord cannot reach a power supply from the work area.
a. When operating a device outside, use an outdoor extension cord marked W-A or W. These cords are
rated for outdoor use and reduce the risk of electric shock.
b. Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). If operating a device in a damp
location is unavoidable, the use of a GFCI reduces the risk of electric shock. It is recommended that the
GFCI should have a rated residual current of 30 mA or less.
2. Do not operate this device if the power cord is frayed or damaged as an electric shock may occur, resulting
in personal injury or property damage.
a. Inspect the device's power cord for cracks, fraying or other faults in the insulation or plug before
each use.
b. Discontinue use if a power cord feels more than comfortably warm while operating the device.
c. Have the power cord replaced by a qualified service technician.
3. Keep all connections dry and off the ground to reduce the risk of electric shock. Do not touch plug with
wet hands.
4. Prevent damage to the power cord by observing the following:
a. Never use the cord to carry the device.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep cord away from heat, oil, sharp edges or moving parts.
5. Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
a. Position power cords away from traffic areas.
b. Place cords in reinforced conduits.
c. Place planks on either side of the power cord to create a protective trench.
4
1/3 HP 2,000 GPH Stainless Steel Sump Pump
For technical questions call 1-800-665-8685
8533606

Publicité

loading