Publicité
When stopping, change the gear directly from the fourth
to neutral; when driving, you do not do that; and instead,
if necessary, change the gear gradually from the higher to
lower and finally neutral.
Reduce speed before down-shifting.
down the pedal rod at the rear part of the gear rod
while slightly increasing the rotation speed of the engine
before the gear rod spontaneously restores to the original
position.
Increase speed before up-shifting. And then pedal down
the pedal rod at the fore part of the gear rod while slightly
decreasing the rotation speed of the engine before the
gear rod spontaneously restores to the original position.
When change the gear according to the steps above,
unnecessary wear on the drive train components and the
rear tire can be prevented.
BCAUTION
Before shifting, close throttle grip completely.
REAR ABSORBER SPRING ADJUSTMENT
The rear absorber spring pre-load is adjustable to
Haojue HJ110-6 99011H56111H000 V04 2021-3-11 09:22
compensate for rider, load, driving style and road
conditions.
positions. Twist the spring tension ring to the desired
position with the spring adjuster.
the softest spring tension and position 5 provides the
And then pedal
stiffest. This motorcycle is delivered from the factory with
its adjuster set on position 1.
The rear absorber springs on the left and right
sides must be placed in the same position.
Improper adjustment will affect ride stability.
REAR BRAKE PEDAL
Depressing the rear brake pedal will
apply the rear brake. The brake light
will be illuminated when the rear
brake is operated.
KICK START LEVER
Located on the right side of the
engine.
13
Haojue HJ110-6 99011H56111H000 V04 2021-3-11 09:22
The spring pre-load is adjustable to five
Position 1 provides
BWARNING
(15)
EN
(15)
Publicité
