Publicité
ELECTRIC STARTUP BUTTON 2 #
This button is used for operating the starter motor. With
the ignition switch at the "*" position and the transmission
in neutral, grasp the brake lever and push the electric
starter button # to operate the starter motor to start the
engine.
BCAUTION
Engaging the starter motor for more than five
seconds at a time can damage the start motor and
wiring harness from overheating.
Do not engage the starter motor for more than
five seconds at a time.
each two usage of electric startup button is about
ten seconds.
If the engine does not start after
several attempts, check the fuel supply and ignition
system.
Refer to the "TROUBLESHOOTING"
section in this manual.
BWARNING
When cleaning the motorcycle, do not clean
its electric parts with the high-pressure water,
particularly its handle switch.
BWARNING
Do not use the electric start function and the kick
lever function at the same time.
Haojue HJ110-6 99011H56111H000 V04 2021-3-11 09:22
The interval between
11
Haojue HJ110-6 99011H56111H000 V04 2021-3-11 09:22
BWARNING
Do not start the motorcycle when the fuel or engine
oil is insufficient.
THROTTLE GRIP 3
The engine speed is controlled by the position of the
throttle grip. Turn it toward you to increase engine speed.
Turn it away from you to decrease engine speed.
FRONT BRAKE LEVER 4
The front brake is applied by grasping the brake lever
gently toward the throttle grip. The brake light will be alight
when the brake lever is grasped inward.
FUEL TANK
1Fuel level 2Filler neck
The fuel tank is located below the saddle. When the fuel
tank is to be refueled, open the saddle lock, lift the saddle,
rotate the fuel tank cap anticlockwise and remove it. After
the refueling is finished, pay attention to its slot and install
the fuel tank cap, and screw up it clockwise, press down
the saddle and lock the saddle lock.
(13)
EN
(13)
Publicité
