Preparation For Installing The Unit; Environment - Ingeteam INGEREV RAPID 50 Trio Manuel D'installation Et Usage

Preparation for installing the unit

5. Preparation for installing the unit
When deciding the location of the unit and planning your installation, you must follow a set of guidelines based on
the specifications of the unit. These guidelines are summarized in this chapter.

5.1. Environment

• These units can be installed indoors and outdoors.
• Situate the units in a place that is accessible for installation and maintenance work and which allows
access to the control panel.
• Avoid corrosive environments that may affect the proper operation of the unit.
• Do not leave objects on top of the unit or its sides, as they may block the ventilation and cause high
temperatures.
• Do not expose it to direct sunlight.
• Do not install the units in inhabited rooms, due to the noise produced during operation.
• If they are installed inside a closed space (room, hut, etc.), provide adequate ventilation. The operating
range of the units depends on the environmental temperature, therefore a lack of ventilation may limit
their capacity.
• If more than one unit is installed, make sure the hot air extraction of one does not interfere with the
correct ventilation of another, leaving a lateral separation of at least 2 meters.
• Keep the following minimum distances free of obstacles.
ABT2012IQM01_B - Installation and Operation Manual
Ingeteam
EN
ES
FR
IT
21