Prepare The Connections; Prepare The Installation Of The Charger - Ingeteam NEO Manuel D'installation Et Usage

Ingeteam

3.1.5. Prepare the connections

Following the template's indications, carry out the following steps:
1. Place the tube for the power supply wiring at the indicated height.
2. Cut and strip the cables to the recommended length.
3. Fit the ferrules.
CAUTION
Always use a suitable tool (crimper) to avoid bad connections that can cause overheating in the connection
terminals.

3.1.6. Prepare the installation of the charger

1. Mark the holes to be made.
2. Drill the holes.
10
20 mm hollow
crimp ferrule
25 cm
Connection tube
5.5 cm
ABV2011IQM01_ - Installation and Operation Manual
Installation