Configuring The Wattmeter - Ingeteam INGEREV SMART DLM Manuel D'installation Et Configuration

INGEREV SMART DLM

4.3 Configuring the wattmeter

Configuration of the wattmeter for the correct operation of the SMART DLM.
1. Power the wattmeter from the electricity
grid.
2. Turn the switch to position 1.
3. Access the configuration menu by
pressing the joystick for 3 seconds. An
access code will be requested. This code
is 0, by default. Once you have entered
the code, press the joystick once to
accept.
4. This gives you access to the password
configuration screen CNG PASS. We
would advise you not to change the
password and to move the joystick to the
right to go to the next screen.
5. APPLICAT application type screen. In this
screen, you need to select application
type H. To do so, press the joystick once.
PRG will appear at the bottom of the
display, indicating that it is possible to
change the value.
Move the joystick in any of the 4 directions
until TYP.H appears. Press the joystick
once to accept
ABW2012IQM01_B
Ingeteam
EN
ES
FR
IT
13