Samsung DVD-VR330 Manuel D'instructions page 134

Setting Up the Audio
Options
Allows you to setup the audio device and sound status
settings depending on the audio system in use.
With the unit in Stop mode/No Disc mode, press
1
the MENU button.
Press the ...† buttons to select Setup, then press
2
the ENTER or √ button.
DVD-Recorder
No Disc
Timer Rec.
System
Clock Set
Setup
Channel Set
Language
Audio
Video
Parental Control
MOVE ENTER
Press the ...† buttons to select Audio, then press
3
the ENTER or √ button.
Audio setup menu will be displayed.
DVD-Recorder
No Disc
Timer Rec.
Digital Output
DTS
Setup
Dynamic Compressiom : On
MOVE ENTER
Press the ...† buttons to select the desired audio
4
option, then press the ENTER or √ button.
Press the ...† buttons to select the desired item,
5
then press the ENTER or √ button.
Press the RETURN or œ button to return to the
previous menu.
Note
Press the MENU button to exit the menu.
Setup
√ √
√ √
√ √
√ √
√ √
√ √
√ √
RETURN EXIT
Audio
: PCM
√ √
: Off
√ √
√ √
RETURN EXIT
Digital Output
1. PCM : Converts to PCM(2CH) 48kHz audio.
Select PCM when using the Analog Audio
Outputs.
2. Bitstream : Converts to Dolby Digital Bitstream
(5.1CH). Select Bitstream when using
the Digital Audio Outputs.
Be sure to select the correct Digital Output or
no audio will be heard.
Note
DTS
1. Off : Doesn't output digital signal.
2. On : Outputs DTS Bitstream via digital output
only. Select DTS when connecting to a DTS
Decoder.
When DTS soundtrack is played, sound is not
output from Analog Audio Output.
Note
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. On : When the Movie soundtracks are played at
low volume or from small speakers, the
system can apply appropriate compression
to make low-level content more intelligible
and prevent dramatic passages from getting
too loud.
2. Off : You can enjoy the movie with the standard
Dynamic Range.
English - 35