Samsung DVD-VR330 Manuel D'instructions page 119

Connecting to Component video input jacks (Y,P
Connect Component video cables (not supplied) between the COMPONENT OUT (Y,P
DVD Recorder & VCR and COMPONENT IN (Y,P
• You will enjoy high quality accurate color reproduction
images. Component video separates the picture
element into black and White(Y), blue(P
signals to present clear and clean images.
• Connect audio cables(white and red) between the
Component AUDIO OUT jacks on the DVD Recorder &
VCR and Component AUDIO IN jacks on TV(or AV
amplifier). (See pages 21 ~ 23)
• Progressive scan
- If the your TV supports Progressive Scan, you can
enjoy higher quality video by pressing the P.SCAN
button. (The component cable has to be connected.)
1. With the unit in stop mode, press the P.SCAN but-
ton on the front of the DVD Recorder & VCR.
2. The message 'Press "Yes" to confirm Progressive
scan mode. Otherwise press "No"' will appear.
Press the œ √ buttons to select Yes, and then
press the ENTER button.
20 - English
,P ) jacks on your TV (or AV amplifier).
B R
Component Cable
green
blue
red
Note
), red(P )
B R
,P )
B R
,P ) jacks on
B R
COMPONENT
green
Y
(not supplied)
P
B
blue
P
red R
Compared to standard interlaced video, progres-
sive scan doubles the amount of video lines fed to
your TV, resulting in a more stable, flicker-free,
and clear image than interlaced video. The pro-
gressive scan video output jack is used in pro-
gressive output mode. This is only available with
TVs that support progressive scan.
Progressive Scan Output (480p) Consumers
should note that not all high definition television
sets are fully compatible with this product and may
cause artifacts to be displayed in the picture.
If you experience 480p progressive scan picture
problems, it is recommended that you switch the
connection to the 'standard definition' output. If
there are questions regarding TV set compatibility
with this model, please contact our customer
service center at 1-800-SAMSUNG.