Publicité
EN
Installing the AR20410T Receiver
1.
Mount the receiver using the four rubber mounting grommets on the side
of the case, screwed into a solid mounting platform. The receiver may be
mounted in any mounting orientation.
2.
If using the optional Synapse sensor, mount the sensor square/parallel with
the centerline of the airplane. It only needs to be parrallel to the centerline,
it does not need to be on the centerline of the airplane.
3.
If using the optional Synapse sensor, Connect the cable between the
sensor and receiver.
IMPORTANT: For SAFE setups, install the Synapse sensor as close to the
center of gravity of the aircraft as practical.
4.
Connect the servos to their respective ports on the receiver.
CAUTION:
installation of the sensor could cause a crash. Always perform a
control surface check and AS3X+ control surface response test before flying
a new setup, or after any setup changes. We recommend using the gyro
response test setting to make gyro direction more visible, see AS3X+
Reaction Test in this manual for more information.
DEFAULT CHANNEL ASSIGNMENTS
Default channel assignments will change with transmitter selections for wing,
tail, flaps and more. Follow the channel assignments defined in your transmitter
after going through configuration for your model.
For electric models using a Spektrum Avian ESC, the throttle port should
always be the #1 servo port, for Smart telemetry to function. Throttle will
function in other channels, but there will not be telemetry. To use a Avian ESC
in Smart mode and change needs to be mande after binding. Enter Forward
Programming, select Other Settings, select Frame Rate, and change the
Output Channel 1 to SRXL2. For more information about using an ESC, see
Powering the AR20410T from the Servo Rail later in this manual.
You may use up to 14 channels in 14 ch mode for primary flight controls. Or,
use up to 12 channels for flight controls, and channels 13–20 as secondary
functions, called XPLUS channels. Enable XPLUS mode in your transmitter
under the frame rate menu to enable these channels. XPLUS channels should
be used for axillary controls, not primary flight controls.
IMPORTANT: When using Y-harness or servo extensions with Spektrum
equipment, do not use reversing harnesses. Using reversing Y-harnesses or
servo extensions may cause servos to operate erratically or not function at all.
6
when using the Synapse and AS3X+, incorrect
Publicité
