Publicité
EN
Troubleshooting Guide
Problem
Aircraft will not
respond to throttle
but responds to
other controls
Aircraft will not
Bind (during bind-
ing) to transmitter
18
Possible Cause
Throttle not at idle
and/or throttle trim
too high
Throttle servo travel is
lower than 100%
Throttle channel is
reversed
Motor disconnected
from ESC
Aircraft or transmitter
is too close to large
metal object, wireless
source or another
transmitter
The bind plug is not
installed correctly in
the bind port
Flight battery/
transmitter battery
charge is too low
Bind button not held
long enough during
bind process
Solution
Reset controls with throttle
stick and throttle trim at lowest
setting
Make sure throttle servo travel
is 100% or greater
(With battery disconnected from
aircraft) Reverse throttle channel
on transmitter
Make sure motor is connected
to the ESC
Move aircraft and transmitter
to another location and attempt
binding again
Install bind plug in bind port
and bind the aircraft to the
transmitter
Replace/recharge batteries
Power off and repeat bind
process.
Publicité
