Publicité
4. Press the clamp as shown.
5. Connect the electrical harness.
6. Connect the wire connectors.
CAUTION
Make sure the wire connectors are connected
properly. Otherwise, the display will not operate.
7. Insert the hinge covers with the front sides
first, and then tighten the screws. Use a Phillips
screwdriver for this step.
SBS_RS4000D_DA68-04820F-01_EN.indd 11
SBS_RS4000D_DA68-04820F-01_EN.indd 11
STEP 2 Adjust the levelling feet
CAUTION
• The refrigerator must be levelled on a flat, solid
floor. Failing to do so can cause damage to the
refrigerator or physical injury.
• Levelling must be performed with an empty
refrigerator. Make sure no food items remain
inside the refrigerator.
• For safety reasons, adjust the front side a little
higher than the rear side.
The refrigerator can be levelled using the front legs
that have a special screw (leveller) for levelling
purposes. Use a flat-head screwdriver for levelling.
To adjust the height of the freezer side:
Insert a flat-head screwdriver into the leveller
of the freezer-side front leg. Turn the leveller
clockwise to raise, or turn it counter clockwise to
lower.
To adjust the height of the fridge side:
Insert a flat-head screwdriver into the leveller
of the fridge-side front leg. Turn the leveller
clockwise to raise, or turn it counter clockwise to
lower.
NOTE
We recommend that the gap between the
refrigerator and nearby walls (or cabinets) is more
than 2" (50 mm).
Installation
11
2024-07-18( )
2024-07-18( )
11:22:56
11:22:56
Publicité
