Publicité
Draining the waste water
WARNING
Environmental pollution!
Environmental pollution due to improper disposal in waste
water.
Observe the local waste water treatment regulations.
1. Remove the drain hose from the support and lower it
over a suitable collecting device.
Illustration N
2. Squeeze or kink the drain hose at the intended point.
3. Open the cover of the drain hose.
4. Drain the waste water. Regulate the water volume by
pressing or kinking.
5. Rinse the waste water tank with clear water.
Waste water tank flushing system
1. Remove the waste water drain hose from the holder and
lower it over a suitable collecting device.
2. Open the dosing unit cover at the drain hose.
3. Open the waste water tank cover.
4. Pull the flexible cap off the flushing system.
5. Connect the water hose to the flushing system.
Illustration O
Lock
1
Tank ventilation flap
2
Flushing system water connection
3
6. Close the waste water tank cover.
7. Open the water supply and flush the waste water tank
for about 30 seconds.
If necessary, repeat the flushing process 2 - 3 times.
8. Close the water supply and disconnect the hose from
the device.
9. Reattach the flexible cap to the water inlet of the flushing
system.
10.Close the cover of the waste water tank. Press the tank
ventilation flap in so that a gap remains open and the
waste water tank can dry.
11.Push the waste water drain hose into the holder and
closed the cover of the dosing device.
Draining fresh water at the cap
1. Open the fresh water tank cap.
2. Drain the fresh water.
3. Clean the filter.
4. Fit the fresh water tank cap.
Draining fresh water via the filling level indicator
1. Remove the filling level indicator hose from the holder
and pivot it down.
2. Reattach the hose.
Emptying the coarse dirt container
(R cleaning head only)
1. Lift the coarse dirt container and pull it out.
Illustration P
Coarse dirt container
1
2. Empty the coarse dirt container and clean it if neces-
sary.
3. Reinstall the coarse dirt container.
Parking the device
1. Turn the program switch to position "0".
2. Remove the Intelligent Key.
3. Press the raise/lower cleaning head lever down and
latch it towards the right.
16
4. Pivot the suction bar lowering lever upwards.
5. Secure the device against rolling away.
6. Close the cover of the waste water tank. Press the tank
ventilation flap in so that it engages in the groove of the
fresh water tank so that the waste water tank can dry.
7. Charge the battery if necessary.
DANGER
Driving on slopes
Risk of injury
Observe the maximum permissible gradient when operat-
ing the device on slopes for loading and unloading purpos-
es (see chapter "Technical data").
Drive slowly.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transport.
Only load the device with the dirt and fresh water tanks
empty.
Only load the device with the assistance of another person
or by using the drive.
1. Press the raise/lower cleaning head pedal down and
latch it towards the right.
2. Remove the brushes to avoid damage.
3. Remove the suction bar from the device.
4. When transporting in vehicles, secure the device
against slipping and tipping over using the transport
eyelets according to the respectively applicable guide-
lines.
Illustration Q
CAUTION
Risk of injury or damage due to non-observance of the
weight
Be aware of the weight of the device during storage.
ATTENTION
Frost
Destruction of the device through freezing water
Drain all water from the device.
Store the device in a frost-free location.
● This device may only be stored indoors.
● Fully charge the batteries before storing them for a long
period.
● Fully charge the batteries at least every month during
storage.
Care and maintenance
DANGER
Inadvertently starting up device
Risk of injury
Turn the program switch to the "0" position.
Remove the Intelligent Key prior to all work on the device.
Pull out the charger mains plug.
Drain and dispose of the waste water and fresh water.
Safety inspection/maintenance contract
You can agree on regular safety inspections or close a
maintenance contract with your dealer. Please seek advice
on this.
English
Transport
Storage
Publicité
