Publicité
ATTENTION
Risk of damage to the batteries!
Using water with additives will void the battery's warranty.
Top up the batteries using only distilled or desalinated wa-
ter (EN 50272-T3).
Do not use any foreign additives or touch-up agents.
1. Add distilled water one hour before the charging pro-
cess comes to an end. Observe the correct acid level
according to the battery label.
All cells must produce gas at the end of the charging
process.
Switching on the device
1. Insert the Intelligent Key into the control panel.
2. Set the program switch to a cleaning program.
The display shows the following, one after the other:
● Kärcher Logo
● Time until next service in hours
● Battery status and operating hours
● Software version
● Operating display
Illustration I
Battery charge state
1
Set water dosage (only for devices with an electric wa-
2
ter valve)
Set speed
3
Set detergent dosage (only for DOSE device variant)
4
The device is ready for operation.
Pairing with a smartphone
The "Machine Connect" smartphone app connected to the
device can be used to perform advanced device functions:
● Set the type of cleaning head
● Set the maximum transport speed
● Switch the USB port off/on
● Set the after-running time of the brush(es)
● Set the after-running time of the suction
● Switch the speed-dependent water dosing on/off
● Manage the permissions of the yellow Intelligent Key
● Restore the factory settings
Note
The possible functions depend on the device version.
1. Scan the QR code on the device with your smartphone.
Illustration J
QR code
1
Bluetooth® symbol
2
2. Install the "Machine Connect" app on the smartphone
and start it.
3. Insert the Intelligent Key into the control panel.
4. Press the "+" and "-" keys on the control panel of the de-
vice simultaneously for 3 seconds.
Note
The Bluetooth® symbol on the control panel flashes during
the pairing process.
5. Follow the pairing instructions of the app on the smart-
phone.
6. The functions of the app are explained on the smart-
phone.
Note
The Bluetooth symbol lights up continuously when the
smartphone is paired with the device.
Note
The mobile phone can be connected to the USB port of the
device to charge the battery.
Maintenance requests
After a certain operating time has elapsed, the display
prompts to perform various maintenance activities:
Call
CLEANING VACUUM FIL-
TER
CLEANING SUCTION BAR 20
CLEANING FILTER WATER 50
CHECK BRUSH WEAR
CHECK SUCTION LIP
1. Carry out the indicated maintenance activity.
2. Press any button on the control panel to confirm.
The prompt is reset and displayed again after the inter-
val has elapsed.
DANGER
Risks during operation
Risk of injury
Release the driving lever in the case of danger.
Loss of stability
Risk of injury
Operate the pedal to raise/lower the cleaning head with
one foot only. Keep the other foot firmly and securely on
the floor.
Filling with operating materials
Filling with fresh water
1. Open the fresh water tank cap.
2. Fill fresh water (max. 50 °C) to the lower edge of the fill-
ing nozzle.
Note: The fresh water hose can be clamped with the
hose holder during filling.
3. Close the fresh water tank lock.
Filling with fresh water via the filling hose
1. Pull the filling hose out of the device.
2. Connect the end of the filling hose to a water tap.
3. Remove the fresh water tank cap.
4. Open the water supply (water temperature maximum
50 °C).
5. Observe the filling level of the fresh water tank through
the filling hole.
6. Close the water inlet when the filling level reaches the
lower edge of the filling nozzle.
7. Fit the fresh water tank lock.
8. Disconnect the filling hose from the water tap.
9. Push the filling hose into the device.
Filling with fresh water via the filling system
1. Connect the water hose to the connection nozzle of the
filling system (maximum water temperature 50 °C).
2. Open the water inlet.
3. Monitor the device, the automatic filling system inter-
rupts the water supply when the fresh water tank is full.
4. Close the water inlet.
5. Remove the water hose.
English
Interval (hours)
10
100
100
Operation
13
Publicité
