Publicité
Cannot output 96kHz or 88.2kHz digital audio.
e Check that the Audio Digital Out setting is set to "Down
Sample OFF" (see page 43).
e Some copy protected discs do not output high sampling rate
digital audio.
No DTS audio output.
e When your amplifier is not equipped with DTS decoder, set
the DTS setting to "PCM". Or press the AUDIO button to
select any other audio (see pages 43, 24).
e When playing back a DTS-CD, set the CD Digital Direct
setting to "Normal" (see page 35).
e Check the setting of your amplifier.
Noticeable difference in DVD, CD and Super Audio CD's
volume.
e That is because DVDs, CDs and Super Audio CDs use
different recording methods.
Video
No picture/distorted picture
e Check the connection to the television (monitor)
e Check the operating instructions for the television (monitor)
to make sure that you have the right input selected, etc.
e Use the VIDEO OFF button of the remote control unit to turn
the video on (see page 27).
e If you are using a HDMI connection, make sure it is
configured correctly (see pages 11, 31-32).
e If you are using a component or D1/D2 connection, make
sure it is configured correctly (see page 11).
e When your television/monitor isn't compatible with
Progressive scan, never set the Component Video setting to
"Progressive" (see page 45).
eIf the PAL-NTSC setting is wrongly set, the picture may be
distorted. Try then to restore factory setting (see pages 45,
7).
Picture noise.
e If video from this system has to go through your VCR to get
to your TV, the copy-protection applied to some DVD
programs could affect picture quality. Please connect the
unit directly to your TV.
The image is distorted or monochromatic.
e The color system selected does not match your TV (see page
6).
e Adjust the aspect ratio to correspond to the
television/monitor in use (see page 44).
e If using an S1/S2 S-Video connection, you may need to set
the output signal to "S1" (see page 44).
The aspect ratio of the screen cannot be changed.
e The aspect ratio might be fixed by the disc.
Screen is suddenly stretched when the Setup screen is
opened.
e If the Setup screen is opened during playback of a DVD
being viewed in the letter box format, the screen may switch
to the wide screen format. This is not a malfunction. The
screen will return to normal when the Setup screen is
closed.
DISPLAY button doesn't work.
No message appear on the screen.
e Set the On Screen Display option to "ON" (see page 46).
ANGLE mark doesn't appear on the screen.
e Set both the Angle Indicator option and the On Screen
Display option to "ON" (see page 46).
Picture and sound don't match up.
e Use the lip sync feature to adjust the relative timing of
picture and audio (see page 26).
Word Sync
The MODE button blinks, and the display shows "No
Word!"
e The word sync mode is selected, but there is no clock
source. Turn the word sync mode off (see page 33).
e No word clock is being received. Check cables, connections,
and settings of the clock generator.
The MODE button blinks, and the display shows "WRD
UNLCK!"
e Invalid word sync signal is received. Check the setting of the
clock generator.
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again. This resets the
internal micro-computer which can be disturbed during
electrical storms, power interruptions, et cetera.
49
Publicité
