Publicité
F
i.LINK (AUDIO) terminal
Digital audio from Super Audio CD, DVD-Video, DVD-Audio,
CD and video CD is output from i.LINK (AUDIO) terminal.
Connect this terminal to an amplifier using a commercially
available S400 compatible i.LINK (IEEE1394) 6 pin cable.
Following settings are necessary to use this
terminal:
• Set the Digital Output setting to "ON" (see page 35).
• Set the i.LINK output setting to "60958" or "PCM"
(see page 33).
When you select "60958", properly set the Digital
output formats (see page 43).
Check the following settings if necessary:
Analog output settings (see page 35)
Speaker setup (see pages 41-43)
G
Digital audio output terminals
Digital audio from DVD-Video, DVD-Audio (2ch only), CD
and video CD is output from these terminals.
The unit may be connected using either coaxial or optical
(TOS) commercially available cables to amplifiers including a
decoder, or to digital audio devices such as CD recorders,
etc.
COAXIAL: Use RCA (pin) digital audio cable
OPTICAL: Use optical digital audio cable (TOS)
< The optical terminal is covered by a shutter. Make sure that
the cable is firmly inserted, but do not force the cable when
connecting it or removing it, in order not to cause damage
to the unit.
< This terminal cannot output the digital audio from a Super
Audio CD.
< This terminal cannot output the digital surround audio from
a DVD-Audio disc.
< DVD-Audio disc signals are converted where necessary from
192kHz or 176.4kHz to 96kHz/88.2kHz or 48kHz/44.1kHz.
However, there may be some occasions when digital audio
cannot be output by the unit from such a disc.
Following settings are necessary to use this
terminal:
• Set the Digital Output setting to "ON" (see page 35).
• Properly set the Digital output formats (see page 43).
H
2 ch analog audio output terminals
Use either the XLR or RCA (pin) terminals for analog stereo
output.
If your amplifier has balanced XLR analog audio inputs,
connect the XLR jacks on the unit to the amplifier's XLR
jacks, otherwise use the RCA (pin) connections.
Set "Analog Output" to "2 ch" to downmix the multi-
channel material to two channels (see page 35).
13
Publicité
