Stihl HLA 65 Notice D'emploi page 6

English
Charger
Observe the information in the leaflet
supplied with the STIHL charger and
keep it in a safe place.
Notes on Operation
Remove the battery from
the power tool:
before carrying out inspections,
–
adjustments or cleaning work
before working on the cutting
–
attachment
before leaving the machine
–
unattended
before transporting the machine
–
before storing the machine
–
before performing repairs or
–
maintenance work
in the event of danger or in an
–
emergency
This avoids the risk of the motor starting
unintentionally.
4
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
The trigger switch and trigger
–
lockout must move freely (retaining
latch to ‚) – switches must return to
the idle position when they are
released.
Cutting blades securely mounted
–
and in good condition (clean, move
freely, not warped), properly
sharpened and thoroughly sprayed
with STIHL resin solvent.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Check contacts in battery
–
compartment for foreign matter.
Fit the battery correctly – it must
–
engage audibly.
Never use defective or deformed
–
batteries.
To reduce the risk of accidents, do not
operate your power tool if it is not
properly assembled and in good
condition.
If you use a shoulder strap or full
harness: Practice removing and putting
down the machine as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practicing.
During Operation
Machines without
a telescoping
5m (17ft)
shaft: To reduce
the risk of injury
from moving
blades or falling cuttings, do not allow
bystanders within 5 meters of your own
position. To reduce the risk of damage
to property, also maintain this distance
from other objects (vehicles, windows).
Machines with
telescoping shaft:
15m (50ft)
To reduce the risk
of injury from
moving blades or falling cuttings, do not
allow bystanders within 15 meters of
your own position. To reduce the risk of
damage to property, also maintain this
distance from other objects (vehicles,
windows).
In case of imminent danger or in an
emergency, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery.
Your power tool is equipped with a
system designed to quickly stop the
cutting blades – they come to an
immediate standstill as soon as you
release the trigger switch.
Check this function at regular short
intervals. To reduce the risk of injury, do
not operate your power tool if the cutting
blades continue to run after switch-off.
Contact your servicing dealer.
HLA 65, HLA 85