Kärcher EB 30/1 Mode D'emploi page 9

Inserting the battery pack
1. Slide the battery pack into the holder and lock it in
place.
Illustration D
Operation
Lock/unlock the telescopic handle sideways
The universal joint can be locked to clean deep-pile car-
pets to prevent the telescopic handle from moving side-
ways.
1. To lock the telescopic handle sideways: Actuate the
locking mechanism, slide it down and snap it into
place.
Illustration E
2. To unlock the telescopic handle: Actuate the locking
mechanism, slide it up and snap it into place.
Starting work
1. Switch on the device by pressing the on/off foot
switch.
Illustration F
2. Move the device forwards and backwards for clean-
ing.
3. Use the right side for cleaning close to the edge
(battery pack side).
Stopping work
1. Switch off the device by pressing the on/off foot
switch.
Illustration G
2. So that the telescopic handle is secured in a stable
position during work breaks, place it vertically; a lock
holds it in this position.
Finishing work
1. Switch off the device at the end of work.
2. Empty the dirt receptacle after each cleaning.
3. Press the unlocking button on the battery pack and
remove the battery pack.
4. Charge the battery pack.
Draining the dirt receptacle
1. Unlock and remove the dirt receptacle.
Illustration H
2. Empty the dirt receptacle.
3. Reinsert the dirt receptacle until it latches into place.
Storing the device
1. The device can be hung on the handle; if necessary,
turn the handle (see chapter "Mounting the tele-
scoping handle and handle, and adjusting the
height").
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be operated indoors.
Care and service
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the battery pack.
Cleaning the device
1. Wipe off the device on the outer side with a damp
cloth. Do not use any aggressive agents, e.g. scour-
ing powder.
Cleaning/replacing the roller brush
1. Press the unlocking button and remove the roller
brush.
Illustration I
2. It is best to remove wound hair with a knife or scis-
sors by moving it along the specified cutting edge of
the roller brush. Remove loose hair from the roller
brush.
3. Insert cleaned or new roller brush and check it is fit-
ted correctly.
Troubleshooting guide
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the battery pack.
Charging mode indicator flashes red and green at
the same time
1. The battery pack is already fully charged.
2. Remove the battery pack from the charger.
Charging mode indicator does not light up
1. Check the connection from the charger to the bat-
tery pack.
2. Check the power supply for the socket.
Device does not clean reliably
1. Clean or change the roller brush (see chapter
"Cleaning/replacing the roller brush").
2. Charge the battery pack (see chapter "Charging the
battery pack").
Dirt is thrown out of the device
1. Empty the full dirt receptacle (see chapter "Draining
the dirt receptacle").
Customer Service department
If the malfunction cannot be corrected, the device must
be checked by the Customer Service department.
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
English
Storage
Warranty
9