Publicité
1. Hold the file horizontally (at the correct angle to the
chainsaw guide bar (14)) and file in accordance with
the angle marking on the file holder. Support the file
holder on the top plate and the depth limiter.
2. Always file the cutting link from the inside out.
3. The file only sharpens as it moves forward. Lift the
file off as you move backwards.
4. Do not touch the drive links or fastening links with
the file.
5. Turn the file regularly to avoid wear on one side.
6. Use a piece of hard wood to remove the burr from
cutting edges.
All cutting links must have the same length, otherwise
they will also be of different heights. This causes the
saw chain (15) to run erratically and increases the dan-
ger of breaking.
14 Storage and transport
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
14.1
Preparation for storage
1. Remove the battery.
2. Attach all protective covers.
3. Empty the product completely.
4. Clean and check the product for damage.
14.2
Transport
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
• The product may only be transported on the handle
provided for this purpose.
15 Repair & ordering spare parts
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
44 | GB
ATTENTION
According to the German Product Liability Act, no lia-
bility is accepted for damage caused by improper re-
pairs or by not using original spare parts.
Such work should be performed by a customer ser-
vice centre or an authorised specialists. The same
applies to accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
15.1
Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Battery GO-ABP 2.0 item no.:
Battery GO-ABP 4.0 item no.:
Battery charger GO-BC 2.4 item no.:
Battery charger GO-BC 4.5 item no.:
Battery charger GO-BC 2.4 twin item
no.:
Battery charger GO-BC 4.5 twin item
no.:
StarterKit GO-SK2.0 item no.:
StarterKit GO-SK4.0 item no.:
16 Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of separate-
ly!
• Used batteries or rechargeable batteries that are
not installed permanently in the old appliance must
be removed non-destructively before disposal! Their
disposal is regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
www.scheppach.com
7909201714
7909201715
7909201716
7909201717
7909201718
7909201719
7909201725
7909201726
The packaging materials are re-
cyclable. Please dispose of pack-
aging
in
an
environmentally
friendly manner.
Publicité
