Skil LL9325-00 Guide D'utilisation page 14

For Laser Line Projection
On Walls
Mounting
Three fastening methods are
available for fastening the wall-
mount base to the wall.
1. Fastening with adhesive putty
(included). The adhesive putty
can be use on drywall, wood,
and other suitable surfaces.
Place a piece of adhesive putty on each adhesive putty adhesion
•
compartment of the wall-mount base (Fig. 3).
NOTE: The adhesive putty may be washed and used repeatedly.
To maintain good adhesion, wash the putty frequently and store it
in the adhesive putty storage compartment of the wall-mount base
when not in use. Make sure the adhesive putty is cleaned of any
dust or debris before your operation.
NOTE: Do not use the adhesive putty to fasten the wall-mount base
onto the wall if the wall surface is loose or wet. Always keep the
target wall surface clean.
NOTE: Remove the wall-mount base from the wall slowly after
using, any residue of the adhesive putty remaining on the wall can
be cleaned by rolling the adhesive
putty over the residue.
Mark the point from where you
•
desire the laser line to project.
Place the wall-mount base onto
•
the wall with the marked point
aligned to the center of the view
window (Fig. 4). Press the wall-
mount base until it is adhered
securely and evenly on the wall.
14
Fig. 3
Adhesive Putty
Fig. 4
Marking Point
View Window