Publicité
1. Washout fitting
2. Hose
5.
Start the engine, engage the blade-control lever,
and let the machine run for 1 to 3 minutes with
the blades turning.
6.
Disengage the blade-control lever, shut off the
engine, and wait for all moving parts to stop.
Folding the Handle
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
Figure 26
3. O-ring
4. Coupling
7.
Shut off the water and remove the coupling from
the washout fitting.
Note:
If the machine is not clean after a single
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
8.
Run the machine again and engage the blades
for 1 to 3 minutes to remove the excess water.
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with a blade or thrown
debris can cause injury or death.
g003934
• Replace a broken or missing washout
fitting immediately, before using the
machine again.
• Never put your hands or feet under the
machine or through openings in the
machine.
Figure 27
21
g452947
Publicité
