Publicité
Caution:
To avoid damaging the speakers by inputting a
sudden high level signal, before connecting the
speakers, be sure to switch the power off.
Connect the main pair of the speakers to the
SPEAKERS A terminals, and connect the second pair
to the SPEAKERS B terminals.
Connect the speaker cords to the speaker terminals as
shown in the following illustration.
* Press the lever, insert the stripped end of the
cord, then release the lever so that the cord is
held securely.
Speaker IMPEDANCE SELECTOR
(on Rear Panel)
IMPEDANCE SELECTOR
At: 80 OR MORE
AOR B.eDOR MORE
p-AORS aBTOLESS THAN En
(em)
READ OWNER'S MANUAL BEFORE SETTING,
Cautions:
1. Before setting this selector, be sure to switch the
power off.
2. Together with this section, also refer to "SPEAKERS
Select Buttons" on page 13.
After connecting speakers, set the IMPEDANCE
SELECTOR switch according to the table below.
When
using speakers A or speakers B separately.
Speaker
Selector position
impedance
42,69
A OR B: 42 TO LESS THAN 8 Q
2
ae
82,162
A OR B: 8 Q OR MORE
Te
(on)
When
using speakers A and speakers B together.
Speaker
Selector position
impedance
8Q, 162
A + B: 8 Q OR MORE
Te
CO)
Publicité
