Publicité
a
Cautions on Use of the
Remote Control Unit
Even when the remote control unit is used within
the range shown, if there is any obstacle between it
and the receiver, operation will be impossible.
If you have other appliances controlled by infrared
signals installed in the same room as your AG-
V1020, these could be operated erroneously by
signals from the remote control. (TEAC cannot take
responsibility for any incidental or consequential
damage this may cause.) Conversely, their remote
controls could cause the AG-V1020 to operate
erroneously.
Be careful not to place books, etc. on the remote
control unit. These could press its buttons in which
case its batteries would become exhausted more
quickly.
When the remote control unit is not to be used for
more than a month or so, remove the batteries so
they cannot leak and cause damage.
If they do leak, clean the battery compartment by
wiping with a clean tissue, then insert new
batteries.
= 19
OPERATIONS
The following instructions apply throughout the
"OPERATIONS"
sections uniess otherwise
noted.
© To simplify explanations, they use the names
of buttons and controls on the front panel,
making no mention of the use of remote
control unit.
@ Be sure the TAPE 2 MONITOR
button is set to
OFF (the TAPE MONITOR
indicator will not
a
rin
the
display).
Hereafter, this instruction will not be repeated.
Basic Operations
Source
component
1. Set the VOLUME control to "0". This is to protect
the speakers from a sudden high level signal.
2. Set the LOUDNESS button to the OFF position.
3. Set the BASS, TREBLE and BALANCE controls to
their center (click) positions.
4. Press the POWER button to turn on the power.
5. Select the required source by pressing one of the
function buttons (including the AM and FM
buttons).
To listen to a source other than tape deck 2, check
that the TAPE MONITOR indicator is not shown in
the display; if it is, switch it off by pressing the
TAPE 2 MONITOR
button.
6. Select the speakers to be used with the SPEAKERS
select buttons. For details, refer to "SPEAKERS
Select Buttons" in the following section.
7. Start playing the source component. Gradually
increase the volume with the VOLUME control and
adjust the other controls as required.
Publicité
