Publicité
Status LEDs
LED functions
LED
General & Cellular Error LED. Flashes 1 to 8 times in an 8-second interval to indicate specific error. See section
1
"LED L1 (red)" for errors and common fixes.
Broadband Errors & Panel Communication. Flashes 2 to 8 times in an 8-second interval to indicate a specific
2
error on the broadband path. Also flashes once every time the module communicates with the panel. See
section "LED L2 (yellow)" for errors and common fixes.
Cellular Communication. Flashes every time the cellular signal level is checked and when packets are
3
exchanged with Alarm.com
Cellular Signal Strength Level. Flashes 0 to 5 times to indicate signal strength or toggles on/off slowly when
4
communicating with Alarm.com servers
5
Z-Wave Status & Error LED. See section "LED L5 (yellow)" for patterns.
LED details
LED L1 (red)
L1 flashes when there is a general error or an error on the cellular path. The number of flashes indicates the
error number. If there are two or more errors at the same time, the errors will flash one after the other. The
LED will stay off for at least four seconds between errors.
Number of
flashes
Module cannot communicate with the panel. Ensure section [382] option [5] is ON. Verify panel
1
software is version 1.1 or higher. Check the connectors (between the panel and communicator) and
powercycle the panel. If the error persists, there can be an issue with the module or panel.
The SIM card is missing. The SIM card holder can be found on the module. Verify that the SIM card
2
holder is closed securely and that there is a SIM card in the holder.
The module is trying to register on the HSPA network. If it persists for more than a few minutes, the
module is having problems registering with the HSPA network. Check L4 for signal level. If signal
level is lower than 2 "bars", change the panel's location or use a remote antenna option. If the signal
3
is good, the module can be roaming on a HSPA network that does not partner with our HSPA
providers, or the SIM card was not activated yet because the Alarm.com account was not created
correctly.
L1 L2 L3 L4 L5
Function
Error and solution
- 17 -
Troubleshooting
Publicité
