Publicité
Lighting up the bottom lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Switch on the tool by pressing the power switch and
squeeze the switch lever to light up the bottom lamp.
The bottom lamp keeps on lighting while the switch
lever is being squeezed. The bottom lamp goes out
when the power switch is turned off or approximately 10
seconds after releasing the switch lever.
Fig.4
► 1 . Bottom lamp
NOTE: When the tool is overheated, the bottom lamp
blinks for one minute. In this case, cool down the tool
before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the bottom lamp. Be careful not to scratch the lens of
the bottom lamp, or it may lower the illumination.
Low battery warning
When the remaining battery capacity of even one of
the two batteries becomes low, the power indicator
lamp blinks in red. Charge the batteries or replace the
charged batteries. When the remaining battery capacity
becomes much lower, the power indicator lamp lights up
in red and the tool stops.
Fig.5
► 1 . Power indicator lamp
1
Maintenance warning
When the cumulative operating time of the tool exceeds
45 hours, the maintenance indicator lamp blinks in red.
After 50 hours have elapsed, the maintenance indicator
lamp lights up in red and the tool changes to the main-
tenance mode.
1
Fig.6
► 1 . Maintenance indicator lamp
NOTE: The maintenance mode is selectable. The tool
is initially set to the continuous operation mode.
NOTE: The tool does not work during configuration of
the maintenance mode or during reset of the cumula-
tive operating time.
8 ENGLISH
1
Publicité
