Publicité
Installing or removing dust extractor
attachment
Optional accessory
Installing dust extractor attachment
1.
Install the hose holder as shown in this figure.
1
Fig.13
► 1 . Hose holder 2. Hose
2.
Install the dust cover as shown in this figure.
2
1
Fig.14
► 1 . Dust cover 2. Hose 3. Bit with collar 4. 30 mm -
100 mm (1-3/16" - 3-15/16") 5. Bit without collar
3.
Connect the hose to the hose of the vacuum
cleaner with the hose joint.
NOTE: If the hose is not included, attach the dust
cover to the cleaner's joint or attach it to Makita's
hose ø28.
Removing dust extractor attachment
Remove the dust extractor attachment in the reverse
order of the installation.
2
4
OPERATION
CAUTION:
holding the heavy tool before / during / after oper-
ation to avoid personal injuries.
CAUTION:
smaller pieces, be careful of the flying debris.
CAUTION:
hands. Turn the tool on and apply slight pres-
sure on the tool so that the tool will not bounce
around, uncontrolled. Pressing very hard on the tool
will not increase the efficiency.
CAUTION:
piece is secured before operation. Failure to prop-
erly secure the workpiece may cause the workpiece
to move resulting in injury.
CAUTION:
Instead, break the workpiece around the bit tip.
CAUTION:
the workpiece. Otherwise the tool may starts unin-
tentionally and cause an injury.
CAUTION:
stable floor or ground after use.
NOTE: If the battery cartridge is in low temperature,
the tool's capability may not be fully obtained. In this
case, warm up the battery cartridge by using the
tool with no load for a while to fully obtain the tool's
capability.
Chipping/Scaling/Demolition
3
Always use the soft grip (auxiliary handle) and firmly
hold the tool by both the soft grip and the switch handle
during operation.
5
Fig.15
11 ENGLISH
Keep well-balanced posture when
When you break the debris into
Hold the tool firmly with both
Always make sure that the work-
Do not pull out the tool if stuck.
Do not leave the tool stabbed in
Be sure to place the tool on the
Publicité
