Publicité
Never immerse the product in water or other
liquids!
Do not carry out any modifications or repairs
to the product yourself . The built-in LED
module and built-in LED driver cannot be
replaced .
If the LEDs fail at the end of their lives, the
entire product must be replaced .
The mains cord of this product cannot be
replaced . If the mains cord is damaged, the
product shall be destroyed .
Danger to life by electric shock
Always check the product for damage before
connecting it to the mains . Never use the
product if it shows any signs of damage .
Protect the mains cord against sharp edges,
mechanical stresses and hot surfaces .
Always unplug the mains plug from the socket
before cleaning .
Disconnect the product from the mains supply
if it is not going to be used for some time (e .g .
holiday) .
Verify that the mains voltage on site
corresponds with the operating voltage
required for the product (230 V∼, 50 Hz),
before you use it . Otherwise do not use the
product .
m
CAUTION! RISK OF BURN INJURIES!
To prevent burns, verify the product is
switched off and has cooled down for at least
15 minutes before touching it . The product
can become very hot .
The accessible surface, is very hot when the
lamp is operating .
FIRE HAZARD! Fit the product
so that it is at least 1 .0 metre away
1 .0 m
from the material to be illuminated .
Excessive heat can result in a fire .
WARNING!
light when the product is facing down to a
combustible surface . The exposed surface
may be overheated or ignited .
Do not place burning candles or open fire on
or near the product .
Do not use the product near heat sources
such as radiators or devices emitting heat .
The product is only suited for use with the
built-in LED control gear .
The product continues to draw a small amount
of power even if the product is off as long
as product is connected to supply mains . To
switch the product off completely, unplug the
mains plug from the socket-outlet .
Luminaires shall not be connected after each
other .
The product can be hung up or it can be used
on a flat, stable surface, e .g . floor or table .
The product must not be used as a hand
lamp .
Do not mount the product to a wall or ceiling .
The product may only be used as described
in this user manual .
˜ First use
˜ Unpacking the product
1 . Take the product out of the packaging and
remove all packaging materials and plastic
wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts are
in good condition . If any damage or defect
is detected, do not use the product, but
follow the procedure described in chapter
"Warranty" .
Do not turn on the
GB/IE/NI
9
Publicité
