Publicité
High Altitude
At higher altitudes (over 5,000 feet), 85 octane/85 AKI
(89 RON) gasoline is recommended. High-altitude use may
require a carburetor jet kit to improve performance and
decrease fuel consumption. See any Sears or qualified dealer
for more information.
Connect Hose and Water Supply to Pump
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment will result from failure to follow this
instruction.
NOTE: Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
3.
Before connecting garden hose to water inlet, inspect
inlet screen. Clean screen if it contains debris or have it
replaced if damaged. Refer to section "O-Ring
Maintenance" if inlet screen is damaged. DO NOT run
pressure washer if inlet screen is damaged.
Inspect inlet
screen. DO
NOT use if
damaged;
clean if dirty.
4. Run water through your garden hose for 30 seconds to
clean out any debris.
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6.
Turn ON water and squeeze trigger on gun to purge
pump system of air and impurities.
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
Checklist Before Starting Engine
Review the unit's assembly to ensure you have performed all
of the following:
1.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in engine
crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for properly tightened hose connections (high
pressure and water supply) and there are no kinks, cuts,
or damage to high pressure hose.
5.
Provide proper water supply (not to exceed 100°F).
6.
Be sure to read "Safety Rules" and "Operation" sections
before using pressure washer.
7.
If starting unit after storage, see "Storage" section on
page 21.
9
CAUTION
WARNING
Publicité
