Publicité
3.
Twisting nozzle adjusts spray pattern from a fan pattern
to a narrow pattern.
Usage Tips
•
For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
•
If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
•
DO NOT get closer than 6 inches when cleaning tires.
Using the Turbo Nozzle
The turbo nozzle spins a 0° nozzle stream in a circular
pattern, providing an intense wide-spray pattern for scouring
large surface areas fast and efficient.
A turbo nozzle can easily cut through heavy oil and grease
stains on concrete, brick and plastic and strip paint from
various surfaces. DO NOT use the turbo nozzle on delicate
materials, especially wood. Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you get
the cleaning force you want. Always keep the turbo nozzle in
a constant motion. NEVER dwell on a single spot. Pass over
stubborn stains repeatedly until they are gone using even
strokes.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
The turbo nozzle produces an extremely high
pressure spray which is capable of removing
paint and cutting holes through surfaces if held
too close.
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a hidden area.
To attach the turbo nozzle to the spray gun:
1.
Engage trigger lock on spray gun trigger.
2.
Remove nozzle extension from spray gun, if attached.
3.
Attach turbo nozzle extension to spray gun. Tighten by
hand.
4.
Disengage trigger lock on spray gun trigger.
5.
For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with turbo nozzle.
Applying Detergent with Adjustable Nozzle
Chemicals can cause bodily injury, and/or property
damage.
• Use ONLY pressure washer safe detergents/ soaps.
To apply detergent, follow these steps:
1.
Review use of adjustable nozzle.
2.
Prepare detergent solution as required by job.
3.
Place filter end of detergent siphoning tube into
detergent container.
NOTE: Make sure the filter is fully submerged in detergent
while applying detergent.
Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the filter into a detergent solution bottle, route
tube so as to keep it from inadvertently contacting hot muffler.
4.
Slide adjustable nozzle forward to low pressure mode.
Detergent cannot be applied with nozzle in high pressure
position.
5.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump. Turn on water.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
13
CAUTION
NOTICE
NOTICE
Publicité
