Publicité
How to Stop Your Pressure Washer
1.
Release spray gun trigger and let engine idle for two
minutes.
2.
Move throttle lever on engine to "Slow" position, then
"Stop" position.
Fast
3.
ALWAYS point gun in a safe direction and squeeze spray
gun trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release high pressure, every time you stop engine.
Engage trigger lock when not in use.
4.
Engage trigger lock on spray gun when not in use.
Stop
Throttle
Lever in
STOP
position
How To Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer. The information in this section will tell you
how to adjust the spray pattern and to apply pressure washer
specific detergents.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1. Slide nozzle backward to achieve high pressure. Slide
nozzle forward when you wish to adjust spray to low
pressure mode.
2. Point nozzle down towards a firm surface, disengage
trigger lock, and press trigger to test pattern.
12
WARNING
Publicité
