Publicité
WINTER STORAGE
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
To protect the unit from freezing temperatures:
1.
Follow steps 1-4 in the previous section "After Each
Use".
2.
Use pump saver, Model 6039, to treat pump. This
minimizes freeze damage and lubricates pistons and
seals.
3.
If pump saver is not available, connect a 3-foot section
of garden hose to water inlet adapter. Pour RV-antifreeze
(antifreeze without alcohol) into hose. Pull recoil handle
twice. Disconnect 3-foot hose.
4.
Store unit in a clean, dry area.
LONG TERM STORAGE
If you do not plan to use the pressure washer for more than
30 days, you must prepare the engine and pump for long
term storage.
Protect Fuel System
Fuel Additive:
Fuel will become stale when stored over 30 days. Stale fuel
causes acids and gum deposits to form in the fuel system or
on essential carburetor parts. Prior to storage, if gasoline has
not been treated with a fuel stabilizer, it must be drained
from the engine into an approved container. Then run engine
until it stops from lack of fuel.
When fuel stabilizers are used according to their instructions,
there is no need to drain the gasoline from the engine prior
to storage. Use Briggs & Stratton FRESH START™ fuel
stabilizer, available as a liquid additive or a drip concentrated
liquid cartridge. Run the engine for a short time to circulate
stabilizer throughout the fuel system. Engine and fuel can
then be stored up to 24 months.
If fuel is drained, the use of a fuel stabilizer in the storage
container is still recommended to maintain freshness.
NOTICE
STORAGE
Change Oil
While engine is still warm, drain oil from crankcase. Refill
with recommended grade. See "Changing Oil" on page 18.
Oil Cylinder Bore
•
Remove spark plug and pour about 1/2 ounce (15 ml) of
clean engine oil into the cylinder.
•
Install spark plug and pull starter handle slowly to
distribute oil.
Protect Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump. This prevents freeze damage and lubricates pistons
and seals.
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
NOTE: PumpSaver is available as an optional accessory. It is
not included with the pressure washer. Contact your local
Sears service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Read and follow all
instructions and warnings given on the PumpSaver container.
Other Storage Tips
1. DO NOT store fuel from one season to another unless it
has been treated as described in "Protect Fuel System".
2. Replace fuel container if it starts to rust. Rust and/or dirt
in fuel can cause problems if it's used with this unit.
3. Cover unit with a suitable protective cover that does not
retain moisture.
Storage covers can be flammable.
• DO NOT place a storage cover over a hot pressure washer.
• Let equipment cool for a sufficient time before placing the cover
on the equipment.
4. Store unit in a clean and dry area.
21
NOTICE
WARNING
Publicité
