Publicité
5. Operation
DANGER! Fire hazard!
Never cover the device or place it on
soft objects (e.g. towels). As long as the
device is switched on and/or hot, al-
ways place it on a stable, flat, heat-re-
sistant surface.
DANGER! Risk of injury
through burning!
Never touch the hot brush insert with
ceramic coating 1.
NOTE: Before using it for the first time,
switch the device on for a few minutes and
set it to the highest temperature (200 °C). As
a result of the manufacturing process, you
may notice a slight odour. This is normal and
only occurs during first use. Ensure that the
room is well ventilated.
5.1
Switching on/off and
adjusting temperature
1. Place the device on a heat-resistant sur-
face.
2. Connect the mains plug 6 to a properly
installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
3. Press the on/off button
prox. 2 seconds to switch the device
on. The display 2 shows:
- 160: if prior to switching the device
on, the mains plug was disconnect-
ed.
- The value set last if the mains plug
had not been disconnected after the
device was switched off last.
16 GB
4. Pressing the +/– 3 buttons, set the de-
NOTE: decreasing bar segments indicate
that the device is cooling down. Wait un-
til the desired temperature appears on the
display before straightening your hair.
5. In order to avoid changing the tempera-
6. Press the on/off button
7. Allow the device to cool down on the
Switching off automatically
If you do not press a button on the switched-
on device for 30 minutes, it will switch off
automatically. Before this happens, the tem-
perature display will flash in the display 2.
Press the on/off button
2 seconds to switch the device back on.
4 for ap-
sired temperature between 100 °C and
200 °C using 20 °C increments. Short-
ly after, increasing bar segments on the
display 2 indicate that the device is
heating up.
ture by accidentally pressing the +/-
buttons 3, these buttons are locked au-
tomatically a few seconds after being
pressed last.
- The display 2 shows
are locked
- To unlock: press one of the +/- 3
buttons for approx. 2 seconds. The
buttons are now unlocked. The dis-
play 2 stops showing
prox. 2 seconds to switch the device
off.
heat-resistant surface.
if the buttons
.
4 for ap-
4 for approx.
Publicité
