Lanaform ABPM-100 Manuel D'instructions page 6

EN
•
•
Adjusting to
the correct position
•
•
•
•
Measuring blood pressure
•
•
6 / 68
M-ABPM100-Lot003.indd 6 M-ABPM100-Lot003.indd 6
FR NL DE SL SV
is 1 - 2cm above the crook of your elbow and
above the artery. The pipe is directed towards
the middle of your palm.
Now close the free part of the cuff around your
arm using the Velcro without making it too
tight. You must be able to insert two fingers
under the cuff.
Now connect the cuff's pipe into the cuff's
power supply.
The device must only be used with the
original cuff. The cuff is intended for an
arm circumference of 22 to 30cm.
Rest for about 5 minutes before
taking any measurements. Oth-
erwise, this may cause errors.
Measurements can only be taken when sitting
down or prone. Make sure in every case that the
cuff is at heart level.
Make yourself comfortable before taking your
blood pressure. Make sure that your back and
your arms are well supported on the backrest
and armrests. Do not cross your legs. Put your
feet flat on the floor.
In order not to distort the result, it is important
to remain calm when taking the measurements
and not to talk.
Position the cuff as described above and get into
the position you want to take the measurements.
To start the monitor, press the STOP/START button
. All displays will light up briefly.
(2)
ABPM-100 EN Instruction manual
• To choose the memory location you want, press
the memory function button
• The results of measuring 4 different people or
the morning and evening measurements may
be recorded separately in four memories with
30 places.
• The monitor automatically starts the measur-
ing process.
• You can stop the measuring process at any time by
pressing the STOP/START button
recognises a pulse, the Pulse symbol is displayed.
• The results of measuring the systolic pressure
, diastolic pressure
(10)
are displayed. The irregular heartbeat symbol
(if there is one) and the symbol for ranking
(17)
measuring results flash.
(18)
• Er_ is displayed when the measuring process
has not been carried out correctly. Read the
chapter Error message/Rectifying errors in
these instructions for use and start taking
measurements again.
• Switch off the monitor by pressing the STOP/
START button . The measuring result is then
(2)
recorded in the user memory you have chosen.
• If you forget to switch off the device, it will switch
off automatically after approximately 1 minute.
• Wait at least 5 minutes before taking another
measurement.
EVALUATING THE RESULTS
Irregular heart beat
• This device is able to identify any irregular heart
beat during the measuring process and displays
it, if necessary, after the measuring process with
the corresponding symbol
202112LA090207003 15/11/2021
. ( , , or ).
(3)
. As soon as it
(2)
and the pulse
(11) (12)
.
(17)
15/11/2021 15:41:25 15/11/2021 15:41:25
• This m
a dise
heart
trical
are lat
caused
natura
by stre
consu
If the
proce
for 5 m
the m
pears,
and se
measu
follow
Rankin
• The res
and ev
These
purpo
person
It is im
Your d
for nor
blood
The ra
device
blood
and d
range
range
the sca
the hi
high"