MATERIALS
A
1
Crossbar
B
2
Sidearms
C
2
Extension Bars
D
20
M10 x 35 x 1.5 Bolts, Washers, Lock Washers & Nuts (Grade 10.9)
E
2
M12 x 40 x 1.75 Bolts, Nyloc Nuts and Protection Caps 4off (Grade 10.9)
E1
6
M12 x 45 x 1.75 Bolts, Nyloc Nuts (Grade 10.9)
F
2
End Caps
G
2
M16 x 2.00 x 60 Bolts, Lock Washers & Nuts (Grade 8.8)
This towbar must be used with a Class A50-1 or A50-X towball, with a 'D' and 'S' value greater than or equal to that of the towbar.
FITTING
1.
This towbar is designed to fit the vehicle chassis and any light clusters or lighting boards will need to be removed and
adapted to enable re-fitment.
2.
Loosely attach Sidearms (B) to the outside faces of the chassis using bolts (D).
3.
Loosely attach Crossbar (A) along with Extensions (C) to the Sidearms using bolts (E) & (E1). NB. Bolts (E) are shorter
in length than (E1) to allow for Protection Caps to be fitted.
4.
Attach End Caps (F) to Extension Bars.
5.
Fully tighten bolts to recommended torque settings, ensuring central profile face is vertical.
6.
Attach towball using M16 bolts (G).
7.
Activate Tipper and check for adequate clearance.
Recommended torque settings: Grade 8.8 bolts: M16 - 200 Nm
Fitting
Instructions
Grade 10.9: M12 - 120Nm, M10 - 70Nm
µW0001CL116-FIT$011307160000AÄ
W0001CL116-FIT$011307160000
For Mitsubishi Canter
7.5 tonne Chassis Cab (N2 cat.)
Tipper & Dropside 850mm Chassis
TOWBAR
CL116