Witter DT144U Instructions De Montage

MATERIALS
A 1 Cross Bar Traverse principale
D 2 M12 x 40 x 1.75 Bolts, Lock Washers and Plain Washers.
E 3 M10 x 35 x 1.5 Bolts, Lock Washers, Witter Cage Nuts.
F 1 Angle Bracket.
G 1 Chassis stiffener.
H 2 M10 x 35 x 1.5 Bolts, Plain Washers, Nyloc Nuts
J 1 Nut Strap.
K 1 Cage Nut Strap
L 2 M12 x 40 x 1.75 Bolts, 4-off Plain Washers, Nyloc Nuts
EP 1 Electrical Plate (ZEP3)
FITTING
1. Remove bumper (remove clips along lower edge, clips around wheel arch, 1 tip screw and pull back wheel arch
extensions to reveal push in clips. Carefully pull bumper backwards to release from clips on rear panel.
2. Remove chassis end caps (3 bolts) and insert Left hand chassis stiffener (G) inside chassis, loosely attach Crossbar (A)
to Stiffener (G) using Fasteners (D & H). Loosely attach Stiffener (G) to vehicle chassis using remaining Bolts (D & H).
3. Pre-Assemble Witter Cage Nuts (3-off) to Nut Straps (J & K)
Note: For vehicles built from 2013 onwards use the outer two cage nut holes on Nut Strap (K)
4. Insert Nut straps (J & K) inside right hand chassis opening and loosely attach Crossbar (A) to vehicle chassis using
Fasteners (E). Loosely attach Bracket (F) to chassis and Cross Bar (A) using remaining Bolts (E & H).
5. Fully tighten all bolts.
6. Refit chassis end caps / bumper beam.
7. Refit bumper.
8. Attach the chosen Neck and Electrical Plate (EP) Fully tighten all bolts.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M16 - 214 Nm
Grade 10.9: M12 – 139Nm, M10 – 78Nm
Fitting
Instructions
µW0001DT144U-FIT$010802220000/Ä
W0001DT144U-FIT$010802220000
Towbar
For NISSAN QASHQAI
2007-
DT144U
For
DT144
DT144Q
DT144S