Publicité
WIFI APP TROUBLESHOOTING
PROBLEM
WIFI PAIRING
• Spa control base does
not support WiFi App
FAILURE DURING
function, wrong model.
THE FIRST TIME
• Spa wireless control
SETUP
panel does not support
WiFi App function.
• Wrong version of mobile
device
• Incompatible mobile
device operating system
• Wrong router network
band
• Wrong network name
• Wrong WiFi password
• The setup spa location
is too far from your WiFi
router signal coverage
range.
• The App does not load
• WiFi LED indicator off /
blank
• WiFi LED indicator
fl ashing slowly
• WiFi LED indicator
fl ashing rapidly
• Wrong WiFi pairing
sequence
S AVE THESE INSTRUCTIONS
CAUSE
• Only compatible with the following models: SB-HWF10, SB-HWF20,
SC-WF10, SC-WF20, SB-HSWF10 or SB-HSWF20, printed on the
spa control base electrical rating label.
• Make sure the spa wireless control panel has the WiFi signal icon
.
• Make sure the spa control base and wireless control panel are both
compatible and support WiFi App function.
• Contact Intex Service Center.
• Ensure the right version of mobile devices:
a. iOS - Apple iPhone 6, 6 Plus and greater. Tablet compatibility is
not optimized.
b. Android – All Android phones. Tablet compatibility is not
optimized.
• Ensure the right version of operating system:
a. Apple devices – iOS 12.3 and greater.
b. Android devices – Android 5.0 and greater. For 6.0 and greater
version, you must turn on the GPS signal on your mobile device
for the fi rst time pairing. Once you have successfully paired the
spa and save it, you may turn off the GPS signal.
• Make sure you are connecting to a 2.4GHz network and try to
pair the mobile device with the spa control panel again.
• Make sure you are connecting to the right WiFi router signal and
try to pair the mobile device with the spa control panel again.
• Make sure your mobile device and spa control panel are
connected to the same WiFi router signal.
• Ensure correct WiFi router password. See WiFi pairing section.
• Ensure your mobile device is connected to your WiFi router and
can access and browse the internet.
• Remove the wireless control panel from the control base and
bring it closer to your WiFi router while making sure it's within 5m
(16ft) distance of the control base in order to prevent activating
the error code E81 (transmission signal failure). Then try to pair
the spa control panel with your mobile device. If it can be paired,
your spa is too far away and you need to make sure the entire
SPA is within your WiFi router signal coverage range.
• If you cannot move your spa, then you need to move your WiFi
router or add a repeater/signal booster so that you can receive
signals from your WiFi router at your setup spa location.
• Try to pair the mobile device with the spa control panel again.
• Force-quit the App, re-launch the App and try to pair the spa
control panel with your mobile device again.
• Ensure the right version of mobile devices and operation system.
• Uninstall the "Spa Management App" and reinstall it again. See
WiFi pairing section.
• Not connected, WiFi pairing not successful within 2 minutes after
touching the WiFi pairing button on the spa control panel.
• Try to pair the spa control panel with your mobile device again.
See WiFi pairing section.
• Power off the spa control base and the wireless control panel,
restart the spa and try to pair the spa control panel again.
• If the problem persists, contact Intex Service Center.
• Refer to "WiFi pairing" section
(353IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/19/2021
SOLUTION
353
English
A
Page 33
Publicité
