Publicité
SPA CONTROL PANEL
M
N
Celsius/Fahrenheit Toggle Button: The temperature can be displayed in either Fahrenheit or
Celsius. The system's default is Celsius.
NOTE: The default temperature is 20°C (68°F). Temperature adjustment ranges from 10°C (50°F)
to 40°C (104°F).
WiFi Pairing Button: Touch this button for 5 seconds to begin spa WiFi pairing with your mobile
device.
WiFi LED Indicator Status:
•
ON/Solid: The product is paired up and connected to the home WiFi signal successfully.
•
Flashing slowly: Pairing mode stage. If it's not paired up and not connected to the home
WiFi signal within 2 minutes, the WiFi LED indicator will turn off . Touch the pairing button
for about 5 seconds to repeat the pairing process.
•
Flashing rapidly: WiFi router/internet network problem. Please check "Troubleshooting" for
more details.
•
OFF/Blank: Spa control panel pairing failure or nerver connected to the home Wifi signal.
Keep touching the pairing button
the problem still persists, check "Troubleshooting" for more details.
Sanitizer Button: Use this button to activate and set operating hours for the sanitation
system.
Intex
Spa Management App Setup User Guide
®
The WiFi App Control allows you to turn on/off any function on your spa, and program a schedule for future
use remotely even when not at home from your mobile device.
System and WiFi Router Requirement
The Spa control base hardware communicates over a 2.4GHz network supporting
802.11b/g/n wireless technology. The hardware does not support 5GHz networks. It is
recommended that you turn off your 5GHz network during the Spa Management App setup
WiFi APP
and pairing process.
QR Code
WiFi Pairing
For a successful fi rst time WiFi pairing between the spa wireless control panel and your mobile device,
make sure:
•
To keep the wireless control panel on the spa control base charging dock.
•
The area where the spa will be installed is within your WiFi router coverage range. The area shall be
free from metallic walls/mesh and other objects that may interfere with or reduce the WiFi signal.
•
Turn off the mobile data (2G, 3G, 4G and LTE) function on your mobile device fi rst, and make sure
your mobile device is connected to your WiFi router before pairing the device with the spa control
panel. Check the WiFi signal strength is full by browsing the internet with your mobile device using the
connected WiFi network and ensure the webpage loading speed is fast.
S AVE THESE INSTRUCTIONS
OPERATION (continued)
L: Celsius/Fahrenheit Toggle and WiFi Pairing
M：WiFi LED Indicator
N：Sanitizer Button
L
for about 10 seconds to repeat the pairing process. If
(353IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/19/2021
Button
353
English
A
Page 18
Publicité
